Not known Details About winchester wsr primers

Not known Details About winchester wsr primers

Blog Article

While using the battery cup flush While using the shell foundation the primer cup may very well be far more convex compared to the Winchesters Try out a pair with a little bit more stress to deep seat ( If the loader allows) and see if that makes a big difference.



This can be an more mature thread, you might not receive a reaction, and will be reviving an outdated thread. You should look at creating a new thread.

I need to utilize the lifter ring within the primer cup thingy when Im reloading Leading Guns or maybe the primer wont be complete seated. Given that I typically reload AA's, and now Nitro27/STS/GC's I dont want "the tail to wag the Puppy" and mess up the primer pusher tube adjustment when reloading TGs. I have not had concerns with GS's and Cheddite primers. I reload with a MEC Sizemaster.

I wished to do the test in almost nothing but once fired hulls, so it's got taken a while to burn off throughout the final rotation of hulls to receive to all clean hulls.

Sig stated: I have operate about 5K of Cheddites so far with none issues. I am able to say this since I just taken out & cleaned my firing pin.

I'm sitting down with a shit ton of Nobel Sport 209 primers, which if I bear in mind the right way are virtually the same as Cheddite.

This is certainly an more mature thread, you might not receive a reaction, and could be reviving an previous thread. Be sure to consider creating a new thread.

I labored with staball 6.5 laboratories For many years And that i observed numerous mistakes. All good laboratories have stringent QA/QC suggestions which Otherwise strictly adhered to, will instantly invalidate data. I would like to see Precision's Licensed standards and calibration data for openers.

I have loaded Countless Remington Gun Club, STS, and Nitro hulls and have experienced no problem switching between Get 209's and Cheddites. This matter pops up every now and then and I far too was anxious when primer options grew to become limited.  

cdb1097 said: I consistently swap CX1000's for WW209's, with none reservations, but I shoot a concentrate on load that may be only about 9-10k PSI.

Again, my commendation to templetk-- several good indicators such as the simple fact he analyzed 10 rounds so his data can generate good SD results; and his SDs had been quite tight, indicating to me that he in truth probably was extremely diligent in his loading techniques.

I have not finished any .410 still as I've a bunch already loaded. I do not think I should have any problems with that both.

I’ve fatigued my source of Win 209 and CCI Primers so I started off tonite’s loading using Cheddites. I’m using the gray AA hull. I discovered I needed to decreased the primer/powder tube slightly to have the primers to seat fully compared to the former depth environment I had utilized for Winchester and CCI primers.

But I are ready to navigate some plowed fields and most pastures if they are not much too damp or rough.